A lot of oven builders go with a Harbor Freight 10 inch wet
saw because you can be set up to cut bricks for under $300. The only problem
with a 10 inch wet say is that you can really only cut bricks up to about 4
inches. Probably a little less. A standard firebrick is 9”x4.5”x2.5” so there
would be a lot of brick flipping to cut all the way through. My plan was to buy
a bigger 14 inch saw, use it to build the oven and then sell it for a little
less than I paid for it. Kind of like a long term rental.
I first saw Ron last summer on Craigslist. For a little over
a year I’ve been scanning the Craigslist sales within a 150 mile radius of
Albany for 14 inch wet saw. I hemmed and hawed and there was another saw for
sale near Syracuse but it didn’t have a picture…and then within a week of each
other both saws were gone from Craigslist. Oh well. There was another tempting, but very pricey, saw in Elmira and
a surprising amount of wet saws are for sale on Long Island. Then in November, Ron was back on Craigslist. This time I called.
The owner is contractor and hadn’t used Ron on a job in two
years. He figured he’d sell it and get it out of his shop. But he was a little
reluctant to sell thinking that as soon as he sold the saw, he would need it again. A
number of things delayed me in making an offer again – replacing one of our
vehicles took a lot of time this winter. And then in January, Ron was gone from
Craigslist once again.
My search continued. There was decent looking saw in Andes,
NY that was a little cheaper than Ron. But by the time you factor in a 2 hour drive
each way to even look at it, it didn’t seem worth the $100 in savings.
Through the magic of cell phone logs and a saved Craigslist
search, I still had Ron’s owner’s phone number. In late April, I gave him a
call to make sure Ron was sold. Seemed like there was a good chance he just
took down the ad again. We played a little phone tag and yes, he did still have
Ron and even better, he was still willing to sell. He’d have his mechanic give Ron a once over
and get back to me. A few more phone calls and we agreed on a time for the
sale.
With a little bit of effort I managed to get Ron set up in
my garage. He’s really big. And he can run on 120 or 240V. Apparently on 220V
he can really slice. I’ve ordered a new blade for him and started working on a
few jigs. I’ve built one that can cut an adjustable angle with a set 5 degree
bevel. The hinge has a pin so I’m going to make a few more jigs that can slip
into the same base.
I’m also debating on repainting his tub. Get rid of a little
rust and make the basin shine. Normally I wouldn’t really care, but I want to
keep the firebrick shavings that will settle in the tub to help level the oven
floor.
Nice to meet you, Ron. I look forward to working with you.
